(1) Damage inspection: After the battery is delivered, it should be checked immediately so that the user can quickly grasp the damage or missing parts. Because if the time to reflect the problem is too late, not only will the loss be aggravated, but it will also be difficult to claim against the manufacturer or supplier.
(2) Installation can only be carried out after the above checks have been completed. After the installation is completed, charge it, fully charge it and then float for 72 hours, then perform a full capacity test. If the capacity test is passed, the battery acceptance is completed.
(3) After the acceptance is completed, the battery must be fully charged. After floating for 72 hours, the internal resistance is measured as the base value for judging its performance. If the internal resistance value is within ± 5% of the average value, it is considered to be a resistance match. A battery that exceeds the average value of 5% is best required to be replaced by the supplier, because the battery pack life with too much difference in internal resistance values ​​will be affected.
The storage should be cool and dry, and the high temperature and faster self-discharge rate will increase the internal consumption of the battery.
If it is necessary to charge, if the storage time of the battery has been more than six months, the user does not charge them up, then the guarantees of most manufacturers will not be realized. If the battery is stored in a high temperature 92F environment, this time will become three months.
In a large industrial Brick Making Machine, clay is taken from the quarry, and then carried by conveyor belt or truck/lorry to the main factory, although it may be stockpiled outside before entering the machinery. When the clay enters the preparation plant (Clay Prep) it is crushed, and mixed with water and other additives which may include breeze, a very fine anthracite that aids firing. This process, which is also known as pugmilling, improves the consistency, firing qualities, texture, and colour of the brick. From here, the processed clay can be extruded into a continuous strip and cut with wires, or put into moulds or presses (also referred to as forming) to form the clay into its final shape. After the forming or cutting, the bricks must be dried, either in the open air, in drying sheds, or in special drying kilns. When the bricks have been dried, they must then be fired or 'burnt' in a kiln, to give them their final hardness and appearance.
Brick Making Machine
Brick Making Machine,Clay Brick Making Equipment,Clay Brick Making Machine,Brick Making Equipment
Shandong Shine Machinery Co.,Ltd , http://www.sdshinemachinery.com