The DGX Heavy Duty Single Shaft Shredder has a 750mm diameter profiled rotor made of solid steel, operating at a speed of 45rpm. The concave ground, aggressive 4-way rotating knives are mounted in the grooves of the profiled rotor with special knife holders. This enables a reduction of the cutting gap between the counter knives and the rotor which guarantees a high flow rate, low power consumption and maximum output of shredded material.
The hydraulically operated ram feeds the material automatically in the rotor's cutting chamber by load-related controls. The hydraulic system is equipped with high-pressure valves and volumetric flow controls which can be set according to the requirements of the input material.
Extremely robust pedestal bearing housings are mounted outside the machine and separate to the cutting chamber to prevent dust and dirt penetrating into the oversized bearings. This ensures a long service life and minimum service and maintenance.
Power is transmitted from the motor by a drive belt via an oversized gearbox which is located on the shaft end on one end of the rotor.
A safety switch prevents machine startup when the front panel is open and the machine features emergency stop buttons on the machine body and control panel.
FEATURES
Large diameter flat rotor
Machined pocket knife holders
Optional hard facing
Concave ground square knives
Robust ram construction
Heavy duty guide bearings
Universal couplings
Low speed, high torque geared drive
Powerful hydraulic swing type ram
Reduced footprint - (compared to horizontal pusher designs)
Bolt in drive shafts
Multiple rotor designs
Two speed hydraulic system
Oil cooling on ram and gearbox
Ram comb plate
Amp meter control
OPTIONSHydraulic screen cradleGearbox with shrink discRotor coolingPipe spacerTouch screen PLC Hopper mounted viewing mirrorIncreased motor driveHydraulic driveBespoke colour scheme Turbo hydraulicsHousing wear platesSound absorbing hopperapplication PLASTICSapplication RUBBERapplication WOODapplication BIOMASSapplication PAPERapplication ALTERNATIVE FUELS (RDF/SRF)application DOMESTIC/COMMERCIAL WASTE
The hydraulically operated ram feeds the material automatically in the rotor's cutting chamber by load-related controls. The hydraulic system is equipped with high-pressure valves and volumetric flow controls which can be set according to the requirements of the input material.
Extremely robust pedestal bearing housings are mounted outside the machine and separate to the cutting chamber to prevent dust and dirt penetrating into the oversized bearings. This ensures a long service life and minimum service and maintenance.
Power is transmitted from the motor by a drive belt via an oversized gearbox which is located on the shaft end on one end of the rotor.
A safety switch prevents machine startup when the front panel is open and the machine features emergency stop buttons on the machine body and control panel.
FEATURES
Large diameter flat rotor
Machined pocket knife holders
Optional hard facing
Concave ground square knives
Robust ram construction
Heavy duty guide bearings
Universal couplings
Low speed, high torque geared drive
Powerful hydraulic swing type ram
Reduced footprint - (compared to horizontal pusher designs)
Bolt in drive shafts
Multiple rotor designs
Two speed hydraulic system
Oil cooling on ram and gearbox
Ram comb plate
Amp meter control
OPTIONSHydraulic screen cradleGearbox with shrink discRotor coolingPipe spacerTouch screen PLC Hopper mounted viewing mirrorIncreased motor driveHydraulic driveBespoke colour scheme Turbo hydraulicsHousing wear platesSound absorbing hopperapplication PLASTICSapplication RUBBERapplication WOODapplication BIOMASSapplication PAPERapplication ALTERNATIVE FUELS (RDF/SRF)application DOMESTIC/COMMERCIAL WASTE
Boyang Compressor Co.,LTD , http://www.bycompressor.com